Digit Map For A Specific Line Configuration - Yealink SIP-T2 Series Administrator's Manual

Administrator's Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
send key. It is only applicable to the off-hook dialing.
The off-hook dialing includes: pick up the handset, press the Speakerphone key or press the line key
when the phone is idle.
Note: It works only if "dialplan.digitmap.enable" or "account.X.dialplan.digitmap.enable" is set to 1
(Enabled). The value configured by the parameter "account.X.dialplan.digitmap.apply_to.press_send"
takes precedence over that configured by this parameter.
Permitted 0-Disabled
Values 1-Enabled
Default 1
Parameter dialplan.digitmap.apply_to.prefix_key
It enables or disables the phone to apply the predefined string of the digit map after pressing a Prefix key.
Description
Note: It works only if "dialplan.digitmap.enable" or "account.X.dialplan.digitmap.enable" is set to 1
(Enabled).
Permitted
0-Disabled
1-Enabled
Values
Default 1

Digit Map for a Specific Line Configuration

The following table lists the parameters you can use to configure digit map for a specific line.
Parameter account.X.dialplan.digitmap.enable
It enables or disables the digit map feature for the account X.
Description
Note: The value configured by the parameter "account.X.dialplan.digitmap.enable" takes precedence
over that configured by the parameter "dialplan.digitmap.enable".
Permitted
0-Disabled
1-Enabled
Values
Default 0
Parameter account.X.dialplan.digitmap.string
It configures the digit map pattern used for the dial plan.
Example:
account.1.dialplan.digitmap.string = <[2-9]x:86>3.T|0x.!|1xxx
Description
Note: The string must be compatible with the digit map feature of MGCP described in 2.1.5 of RFC 3435. It
works only if "account.X.dialplan.digitmap.enable" is set to 1 (Enabled). The value configured by the para-
meter "account.X.dialplan.digitmap.string" takes precedence over that configured by the parameter "dial-
plan.digitmap.string".
Permitted
String within 2048 characters
Values
Default Blank
Parameter account.X.dialplan.digitmap.interdigit_long_timer
It configures the time (in seconds) to wait before dialing an entered number if it matches part of any
Description
string of the digit map for the account X.
270
<y0000000000xx>.cfg
[1]
<MAC>.cfg
[1]
<MAC>.cfg
[1]
<MAC>.cfg