Call Forward; Call Forward Settings Configuration - Yealink SIP-T2 Series Administrator's Manual

Permitted
Integer from 3 to 3600
Values
Default 5

Call Forward

You can forward calls from any line on your phone to a contact. There are two ways of forwarding your calls:
Forward calls in special situations, such as when the phone is busy or there is no answer, or forwarding all incoming
l
calls to a contact immediately.
You can set the phone not to forward a call coming from authorized numbers.
Manually forward an incoming call to a number.
l
Topics

Call Forward Settings Configuration

Call Forward Feature Configuration
Call Forward Synchronization for Server-side Configuration
Call Forward Settings Configuration
You can change the following call forward settings:
Enable or disable the call forward feature. If disabled, the users have no permission to configure call forward on
l
their phone.
Choose a call forward mode. You can configure call forward for all lines or specific lines.
l
Allow or disallow users to forward an incoming call to an international telephone number (the prefix is 00).
l
Enable or disable forward emergency feature and specify forward authorized numbers. These numbers will not be
l
forwarded when the call forward feature is enabled. The incoming call will not be logged in the Forwarded Calls list.
Enable or disable the display of the Diversion header. The Diversion header allows the phone which receives a for-
l
warded-call to indicate where the call was from.
The following table lists the parameters you can use to change the call forward settings.
Parameter features.fwd.allow
Description It enables or disables the call forward feature.
Permitted
0-Disabled, call forward feature is not available to the users.
1-Enabled
Values
Default 1
Parameter features.fwd_mode
It configures the call forward mode.
Description
Note: It is not applicable to T19(P) E2/CP920 IP phones. It works only if "feautes.fwd.allow" is set to 1
(Enabled).
0-Phone, call forward feature is effective on a phone basis.
Permitted
Values
1-Custom, you can configure call forward feature on a per-line basis.
Default 0
Web UI Features->Forward&DND->Forward->Mode
<y0000000000xx>.cfg
<y0000000000xx>.cfg
Call Features
307