Edk List Configuration - Yealink SIP-T2 Series Administrator's Manual

Administrator's Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
The following table lists the parameters you can use to configure EDK.
Parameter features.enhanced_dss_keys.enable
Description It enables or disables the Enhanced DSS Keys (EDK) feature.
Permitted
0-Disabled
1-Enabled
Values
Default 0
Parameter edk.id_mode.enable
It enables or disables to view the softkey or menu item ID by long pressing the Volume Up key for three
seconds on any screen.
Description
Note: The menu item ID is displayed on the status bar of the phone. Long pressing the Volume Up key
again for three seconds to exit. It works only if "features.enhanced_dss_keys.enable" is set to 1 (Enabled).
Permitted
0-Disabled
1-Enabled
Values
Default 0

EDK List Configuration

Using the Enhanced DSS Keys (EDK) List parameters to define a macro is useful when defining more than one soft key
or DSS key.
The following table lists the parameters you can use to configure EDK list.
Parameter edk.edklist.X.enable
It enables or disables Enhanced DSS Keys (EDK) macro X.
Description
Note: It works only if "features.enhanced_dss_keys.enable" is set to 1 (Enabled).
Permitted 0-Disabled
Values 1-Enabled
Default 0
Parameter edk.edklist.X.mname
It configures the unique identifier used by the soft key or DSS key configuration to reference the
enhanced DSS keys entry for macro X.
Description
It cannot start with a digit. This parameter must have a value, it cannot be left blank.
Example:
178
[1]
[1]
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg