Yealink SIP-T2 Series Administrator's Manual page 57

Parameter static.network.pc_port.enable
It enables or disables the PC port.
Description
Note: It is not applicable to CP920 IP phones.
0-Disabled
Permitted
Values
1-Auto Negotiation
Default 1
Web UI Network->PC Port->PC Port Active
Parameter static.network.internet_port.speed_duplex
It configures the transmission method of the Internet port.
Note: For T54S/T52S/T48S/T48G/T46S/T46G/T42G/T42S/T40G/T29G/T27G/T23G/CP920 IP phones, you can
Description
set the transmission speed to 1000Mbps/Auto Negotiation to transmit in 1000Mbps if the IP phone is con-
nected to the switch supports Gigabit Ethernet. We recommend that you do not change this parameter.
0-Auto Negotiation
1-Full Duplex 10Mbps
2-Full Duplex 100Mbps
Permitted
3-Half Duplex 10Mbps
Values
4-Half Duplex 100Mbps
5-Full Duplex 1000Mbps (only applicable to
T54S/T52S/T48S/T48G/T46S/T46G/T42G/T42S/T40G/T29G/T27G/T23G/CP920 IP phones)
Default 0
Web UI Network->Advanced->Port Link->WAN Port Link
Parameter static.network.pc_port.speed_duplex
It configures the transmission method of the PC port.
Note: It works only if "static.network.pc_port.enable" is set to 1 (Auto Negotiation). For
T54S/T52S/T48S/T48G/T46S/T46G/T42G/T42S/T40G/T29G/T27G/T23G IP phones, you can set the trans-
Description
mission speed to 1000Mbps/ Auto Negotiation to transmit in 1000Mbps if the IP phone is connected to
the switch supports Gigabit Ethernet. We recommend that you do not change this parameter. It is not
applicable to CP920 IP phones.
0-Auto Negotiation
1-Full Duplex 10Mbps
2-Full Duplex 100Mbps
Permitted
3-Half Duplex 10Mbps
Values
4-Half Duplex 100Mbps
5-Full Duplex 1000Mbps (only applicable to
T54S/T52S/T48S/T48G/T46S/T46G/T42G/T42S/T40G/T29G/T27G/T23G IP phones)
Default 0
Web UI Network->Advanced->Port Link->PC Port Link
Parameter static.network.vlan.pc_port_mode
[1]
<y0000000000xx>.cfg
[1]
<y0000000000xx>.cfg
[1]
<y0000000000xx>.cfg
[1]
<y0000000000xx>.cfg
Phone Network
51