Advisory Tones; Advisory Tones Configuration - Yealink SIP-T3 Administrator's Manual

1-Always
Default
1
Supported
W78H, W73H, W59R, W53H, W56H
Devices
Web UI Features > General Information > End Call On Hook

Advisory Tones

Advisory tones are the acoustic signals of your handset, which inform you of different actions and states.
It is not applicable to DD phones.
You can configure the following advisory tones independently for each other:
Keypad Tone: plays when you press any key of the keypad. For CP930W, you can only configure it by nav-
l
igating to Menu > Settings > Basic Settings > Sound > Advisory Tones > Keypad Tone. It is not applicable to
CP935W.
Key Tone: plays when you tap the dial pad. It is only applicable to CP935W, you can configure it by navigating to
l
More > Basic > Sound > Advisory Tones > Key Tone.
Touch Tone: plays when you tap the keys (except the off-hook key and the touch keypad). You can only con-
l
figure it by navigating to Menu > Settings > Basic Settings > Sound > Advisory Tones > Touch Tone. For
CP935W, you can only configure it by navigating to More > Basic > Sound > Advisory Tones > Touch Tone. It
is only applicable to CP930W/CP935W.
Confirmation: plays when you save settings or place the handset in the charger cradle. For CP930W, you can
l
only configure it by navigating to Menu > Settings > Basic Settings > Sound > Advisory Tones > Confirmation.
It is not applicable to CP935W.
Low Battery: plays when battery capacity is low and the handset requires being charged. For CP930W, you can
l
only configure it by navigating to Menu > Settings > Basic Settings > Sound > Advisory Tones > Low Battery.
For CP935W, you can only configure it by navigating to More > Basic > Sound > Advisory Tones > Low Bat-
tery Tone.
Topic

Advisory Tones Configuration

Advisory Tones Configuration
The following table lists the parameters you can use to configure the advisory tones.
Parameter custom.handset.keypad_tone.enable
It enables or disables the handset to play a tone when any key is pressed.
Description
Note: It will take effect on all handsets that are registered on the same phone. It works only if "stat-
ic.auto_provision.handset_configured.enable" is set to 1 (Enabled) and the silent mode is off.
-1-Do not modify the handset configuration (Keep the original configuration of the handset).
Permitted
0-Disabled
Values
1-Enabled
Default -1
Supported
W78H, W73H, W59R, W53H, W56H, CP930W
Devices
W78H/W73H/W59R/W53H/W56H:
Handset UI
OK > Settings > Audio > Advisory Tones > Keypad Tone
Using DECT Handsets with T57W/T54W/T53W/T53/T53C Phones
<y0000000000xx>.cfg
142