Multiple Line Keys Per Account; Multiple Line Keys Per Account Configuration - Yealink SIP-T3 Administrator's Manual

Default 0
Supported
All phones except CP920
Devices

Multiple Line Keys per Account

You can assign multiple line keys to associate with a specific account. The line keys are automatically assigned
with Line type from the first unused one (unused one means the line key is configured as N/A or the associated
account is not registered). All calls on this account will be distributed evenly among these line keys. It is useful for
managing a high volume of calls to an account.
When you assign multiple line keys to be associated with an account, you can configure the IP phone whether trans-
ferring a call or setting up a conference call on the current line key or on a new distribution line key.
It is not applicable to T30P/T30/T19(P) E2/CP920 phones.
Topics

Multiple Line Keys per Account Configuration

Auto Line Labels Rule Configuration
Default Account
Multiple Line Keys per Account Configuration
The following table lists the parameters you can use to configure multiple line keys per account.
Parameter features.auto_linekeys.enable
It enables or disables to assign multiple line keys to associate with a specific account.
Description
Note: The number of the line keys is determined by "account.X.number_of_linekey".
Permitted
0-Disabled
1-Enabled
Values
Default 0
Supported
All phones except T30P, T30, T19(P) E2 and CP920
Devices
Web UI
Features > General Information > Auto Linekeys
Parameter account.X.number_of_linekey
It configures the number of line keys to be assigned with a specific account from the first unused one.
Description
If a line key is in used, the phone will skip to the next unused DSS key.
Integer from 1 to 999
Permitted
The number of the line keys varies by phone models, for the supported line keys, refer to
Values
DSS Keys.
Default 1
Supported
All phones except T30P, T30, T19(P) E2 and CP920
Devices
Web UI
Account > Advanced > Number of Line Key
Parameter phone_setting.call_appearance.transfer_via_new_linekey
It enables or disables to distribute a transferring call to a new line key (the new line key is not seized).
If all line keys are seized, the current line key will be used.
Description
Note: The number of the line keys is determined by "account.X.number_of_linekey". The value con-
[1]
Account Settings
<y0000000000xx>.cfg
<MAC>.cfg
Supported
<y0000000000xx>.cfg
349