Installing The Mx240 Air Filter; Figure 88: Installing The Craft Interface - Juniper MX240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide
Related
Documentation

Installing the MX240 Air Filter

230
Align the bottom of the craft interface with the sheet metal above the card cage and
4.
press it into place.
Tighten the screws on the left and right corners of the craft interface faceplate.
5.
Reattach any external devices connected to the craft interface.
6.

Figure 88: Installing the Craft Interface

MX240 Craft Interface Overview on page 12
Removing the MX240 Craft Interface on page 266
Connecting the Alarm Relay Wires to the MX240 Craft Interface on page 267
Disconnecting the Alarm Relay Wires from the MX240 Craft Interface on page 265
Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
To install the air filter (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Locate the up arrow and ensure that the air filter is right side up.
2.
Slide the air filter straight into the chassis until it stops.
3.
Align the captive screws of the air filter cover with the mounting holes on the chassis.
4.
Tighten the captive screws on the air filter cover.
5.
Figure 89 on page 231):
Copyright © 2017, Juniper Networks, Inc.