Mapping Input Power From Ac Power Distribution Modules To Ac Power Supply Modules On Mx2008 Router - Juniper MX2008 Hardware Manual

Table 33 on page 91 lists the single-phase AC power distribution module (PDM) electrical specifications
for the MX2000 line of routers.
Table 33: Single-Phase AC Power Distribution Module Electrical Specifications
Item
AC input voltage
AC input line frequency
AC input current rating
SEE ALSO
MX2008 AC Power Cord Specifications | 82
Mapping Input Power from AC Power Distribution Modules to AC Power
Supply Modules on MX2008 Router
NOTE: The MX2008, MX2010, and MX2020 routers support the same power modules (AC/DC
PSMs and AC/DC PDMs).
You connect AC power to the router by connecting two AC power cords to each AC PDM. One feed maps
to six PSMs and the other maps to three PSMs.
The arrangement matches the internal components of the PDM.
input mapping to AC PDM0/Input0 and PDM1/Input1.
Specification
Operating range: 200–240 VAC (nominal)
50/60 Hz (nominal)
14 A @ 200 VAC
Figure 34 on page 92 shows the mapping for the MX2008.
Table 34 on page 92 shows the AC PDM
91