Figure 62: Reinstalling A Power Supply - Juniper M40E Hardware Manual

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
Place one hand under the power supply and grasp a handle on the faceplate with the
3.
other hand. Slide the power supply into the chassis until it contacts the midplane.
Starting with the bottom screws, tighten (but do not overtighten) the thumbscrew
4.
at each corner of the power supply faceplate.
Repeat the procedure to reinstall the second power supply.
5.
To continue the installation, proceed to "Connecting the M40e Router to Management
6.
and Alarm Devices" on page 111.

Figure 62: Reinstalling a Power Supply

M40e Component Weights
M40e Router Physical Specifications on page 269
M40e System Architecture Overview on page 59
Removing Components from the Chassis Before Installing the M40e Router Without
a Lift on page 83
Installing the M40e Chassis into the Rack on page 95
Chapter 9: Installing the M40e Router Without a Mechanical Lift
107