Reinstalling Components In The Mx2020 Chassis After Installing It In A Rack; Reinstalling The Power Distribution Modules After Installing The Mx2020 In; Rack; Reinstalling The Power Supply Modules After Installing The Mx2020 In A - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide
Related
Documentation

Reinstalling Components in the MX2020 Chassis After Installing It In a Rack

236
NOTE: If the router isn't pulled all the way into the rack by the winch
mechanism, grasp the handles on the shipping covers and carefully slide
the router onto the mounting shelf until the front-mounting flanges contact
the rack rails. You must remove the winch bracket to perform this
procedure.
NOTE: There must be a minimum of 45-U of usable rack space when
installing the MX2020 into a 45-U rack.
Remove the router transport platform, and set the platform aside.
11.
Remove the winch mount and winch strap plate, and set them aside.
12.
Insert sixteen mounting screws (eight on each side) into the mounting holes to secure
13.
the router to the rack.
Visually inspect the alignment of the router. To verify that the router is installed properly
14.
in the rack, see that all the mounting screws on one side of the rack are aligned with
the mounting screws on the opposite side and the router is level.
Reassemble the router transport kit, and set aside.
15.
Overview of Preparing the Site for the MX2020 Router on page 103
Tools Required to Install the MX2020 Router Using a Router Transport Kit on page 191
Installing the Router Transport Kit on the MX2020 Router on page 224
MX2020 Moving Requirements and Guidelines Using a Router Transport Kit on page 113
Removing Components from the MX2020 Router Chassis Before Installing It In a Rack
on page 209
Reinstalling Components in the MX2020 Chassis After Installing It In a Rack on page 236
After the router is installed in the rack, remove the shipping covers, and reinstall the
removed components before booting and configuring the router. You reinstall components
first in the rear of the chassis, and then in the front:
Reinstalling the Power Distribution Modules After Installing the MX2020 In a
1.
Rack on page 237

Reinstalling the Power Supply Modules After Installing the MX2020 In a

2.
Rack on page 239
Reinstalling the Fan Trays After Installing the MX2020 In a Rack on page 240
3.
Reinstalling the SFBs After Installing the MX2020 In a Rack on page 241
4.
5. Reinstalling the Adapter Card After Installing the MX2020 In a Rack on page 242
Copyright © 2015, Juniper Networks, Inc.