Figure 43: Reinstalling A Power Supply - Juniper Core Router T Series Hardware Manual

T320 Core Router Hardware Guide
See Also
Related
Documentation
128
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis. For more information about ESD,
see "Preventing Electrostatic Discharge Damage to a T320 Router" on page
Loosen the captive screws on the installation handle completely, and remove the
2.
handle from the chassis.
Make sure that the circuit breaker on the power supply faceplate is in the off
3.
position ( ).
O
Using both hands, slide the power supply into the chassis until you feel resistance.
4.
Twist the ejector handles at the upper corners of the power supply faceplate clockwise
5.
until they stop.
Tighten the captive screws at the lower corners of the power supply faceplate to
6.
secure the power supply in the chassis.
Repeat the procedure for the upper power supply.
7.

Figure 43: Reinstalling a Power Supply

T320 Router Installation Summary on page 107
T320 Installation Safety Guidelines on page 335
T320 Router Installation Summary on page 107
Overview of Installing the T320 Router Without a Mechanical Lift on page 129
Preventing Electrostatic Discharge Damage to a T320 Router on page 330
T320 Installation Safety Guidelines on page 335
330.
Copyright © 2018, Juniper Networks, Inc.