Subaru Legacy 2005 Service Manual page 1173

17) Separate the center exhaust pipe from rear ex-
haust pipe.
18) Remove the bolt which holds center exhaust
pipe bracket to transmission.
19) Remove the intercooler bracket.
20) Remove the bolt which holds center exhaust
pipe to hanger bracket.
CAUTION:
Be careful not to pull down the center exhaust
pipe.
21) Remove the center exhaust pipe.
B: INSTALLATION
NOTE:
Use a new gasket.
1) Install the center exhaust pipe and temporarily
tighten the bolt which holds center exhaust pipe to
hanger bracket.
2) Temporarily tighten the bolt which holds center
exhaust pipe to transmission.
3) Connect the center exhaust pipe to turbocharg-
er.
Center Exhaust Pipe
Tightening torque:
35 N
EX-02015
4) Install the center exhaust pipe to rear exhaust
pipe.
Tightening torque:
18 N
EX-00208
5) Connect the connector to rear oxygen sensor.
6) Tighten the bolt which holds center exhaust pipe
bracket to transmission.
EX-00209
Tightening torque:
30 N
EX(H4DOTC)-7
⋅
m (3.6 kgf-m, 26.0 ft-lb)
⋅
m (1.8 kgf-m, 13.3 ft-lb)
⋅
m (3.1 kgf-m, 22.1 ft-lb)
EXHAUST
EX-00204
EX-02015
EX-00206
EX-00208