Subaru Legacy 2005 Service Manual page 1273

8) Turn the ignition switch to ON (engine OFF), and
the Subaru Select Monitor power switch to ON.
(A) Power switch
9) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
10) On the «System Selection Menu» display
screen, select the {Engine} and press the [YES]
key.
11) Press the [YES] key after the information of en-
gine type has been displayed.
12) On the «Engine Diagnosis» screen, select the
{D Check} and press the [YES] key.
13) When the "Perform D Check?" is shown on the
screen, press the [YES] key.
14) Perform subsequent procedures as instructed
on the display screen.
• If trouble still remains in the memory, the corre-
sponding DTC appears on the display screen.
NOTE:
• For detailed operation procedure, refer to the
SUBARU SELECT MONITOR OPERATION MAN-
UAL.
• For details concerning DTC, refer to "List of Diag-
nostic Trouble Code (DTC)".
<Ref. to EN(H4DOTC)(diag)-62, List of Diagnostic
Trouble Code (DTC).>
• Release the parking brake.
• The speed difference between front and rear
wheels may light the ABS warning light, but this in-
dicates no malfunctions When engine control diag-
nosis is finished, perform the ABS memory
clearance procedure of self-diagnosis function.
3. GENERAL SCAN TOOL
1) After performing the diagnostics and clearing the
memory, check for any remaining unresolved trou-
ble data. <Ref. to EN(H4DOTC)(diag)-37, Clear
Memory Mode.>
2) Idle the engine.
Inspection Mode
3) Connect the test mode connector (A) located at
the lower portion of glove box.
(A)
EN-00040
4) Connect the general scan tool to data link con-
nector located in the lower portion of the instrument
panel (on the driver's side).
CAUTION:
Do not connect any scan tools except Subaru
Select Monitor or general scan tool.
5) Start the engine.
NOTE:
• Ensure the select lever is placed in "P" position
before starting. (AT model)
• Depress the clutch pedal when starting the en-
gine. (MT model)
6) Using the select lever or shift lever, turn the "P"
position switch and "N" position switch to ON.
7) Depress the brake pedal to turn brake switch
ON. (AT model)
8) Keep the engine speed in 2,500 — 3,000 rpm
range for 40 seconds.
9) Shift the select lever or shift lever in the "D"
range (AT model) or "1st" gear (MT model) and
drive the vehicle at 5 to 10 km/h (3 to 6 MPH).
NOTE:
• For AWD model, release the parking brake.
• The speed difference between front and rear
wheels may light the ABS warning light, but this in-
dicates no malfunctions. When engine control diag-
nosis is finished, perform the ABS memory
clearance procedure of self-diagnosis system.
10) Using the general scan tool, check DTC and
record the result(s).
EN(H4DOTC)(diag)-33
ENGINE (DIAGNOSTICS)
(A)
EN-02424
EN-02097