Subaru Legacy 2005 Service Manual page 1394

Hide thumbs Also See for Legacy 2005:
Table of Contents

Advertisement

Diagnostic Procedure with Diagnostic Trouble Code (DTC)
ENGINE (DIAGNOSTICS)
Step
2
CHECK GENERATOR.
1) Start the engine.
2) Run the engine at idle after warming up.
3) Measure the voltage between generator B
terminal and chassis ground.
Terminals
Generator B terminal (+) — Chassis
ground (
):
3
CHECK GENERATOR.
1) Run the engine at 5,000 rpm.
2) Measure the voltage between generator B
terminal and chassis ground.
Terminals
Generator B terminal (+) — Chassis
ground (
):
4
CHECK BATTERY TERMINAL.
1) Turn the ignition switch to OFF.
2) Check the installation of positive and nega-
tive terminals of battery.
5
CHECK INPUT VOLTAGE OF ECM.
1) Run the engine at idle.
2) Measure the voltage between ECM con-
nector and chassis ground.
Connector & terminal
(B135) No. 5 (+) — Chassis ground (
(B135) No. 6 (+) — Chassis ground (
6
CHECK POOR CONTACT IN CONNECTORS.
Check the poor contact in connectors between
generator, battery and ECM.
7
CHECK ECM.
1) Connect all the connectors.
2) Perform the clear memory mode. <Ref. to
EN(H4DOTC)(diag)-37, Clear Memory Mode.>
3) Perform the inspection mode. <Ref. to
EN(H4DOTC)(diag)-30, Inspection Mode.>
4) Read the DTC. <Ref. to
EN(H4DOTC)(diag)-29, Read Diagnostic Trou-
ble Code (DTC).>
Check if the same DTC is displayed.
8
CHECK OTHER DTC DETECTION.
Check if any other DTC is displayed.
Check
Is the voltage less than 16.2
V?
Is the voltage less than 16.2
V?
Are the positive and negative
battery terminals clamped
tightly?
Is the voltage less than 16.2
V?
):
):
Is there poor contact in con-
nectors between generator,
battery and ECM?
Is the same DTC displayed?
Is any other DTC displayed?
EN(H4DOTC)(diag)-154
Yes
Go to step 3.
Repair the genera-
tor. <Ref. to
SC(H4SO 2.0)-14,
Generator.>
Go to step 4.
Repair the genera-
tor. <Ref. to
SC(H4SO 2.0)-14,
Generator.>
Go to step 5.
Tighten the clamp
of terminal.
Go to step 6.
Repair the har-
ness connectors
between battery,
main relay and
ECM.
Repair the poor
Go to step 7.
contact.
Replace the gen-
Go to step 8.
erator.
Perform the diag-
Temporary poor
nosis of DTC dis-
contact occurs.
played.
No

Advertisement

Table of Contents
loading

Table of Contents