Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step
1
CHECK HARNESS BETWEEN ECM AND OIL
FLOW CONTROL SOLENOID VALVE.
1) Turn the ignition switch to OFF.
2) Disconnect the connectors from ECM and
oil flow control solenoid valve.
3) Measure the resistance between ECM and
oil flow control solenoid valve.
Connector & terminal
(B134) No. 20 — (E63) No. 1:
(B134) No. 30 — (E63) No. 2:
2
CHECK OIL FLOW CONTROL SOLENOID
VALVE.
1) Disconnect the oil flow control solenoid
valve connector.
2) Measure the resistance between oil flow
control solenoid valve terminals.
Terminals
No. 1 — No. 2:
Check
Is the resistance less than 1
Ω?
Is the resistance 6 — 12 Ω?
EN(H4DOTC)(diag)-173
ENGINE (DIAGNOSTICS)
Yes
Go to step 2.
Repair the open
circuit of harness
between ECM and
oil flow control
solenoid valve
connector.
NOTE:
In this case, repair
the following:
• Open circuit of
harness between
ECM and oil flow
control solenoid
valve connector
• Poor contact in
coupling connector
Repair the poor
Replace the oil
contact in ECM
flow control sole-
and oil flow con-
noid valve. <Ref.
trol solenoid valve.
to ME(H4DOTC)-
56, Camshaft.>
No