Subaru Legacy 2005 Service Manual page 1267

6. READ FREEZE FRAME DATA FOR ENGINE. (OBD MODE)
1) On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display screen, select the {Engine} and press the [YES] key.
3) Press the [YES] key after the information of engine type has been displayed.
4) On the «Engine Diagnosis» display screen, select the {OBD System} and press the [YES] key.
5) On the «OBD Menu» display screen, select the {Freeze Frame Data} and press the [YES] key.
• A list of the support data is shown in the following table.
DTC for freeze frame data
Air fuel ratio control system for bank 1
Engine load data
Engine coolant temperature signal
Short term fuel trim by front oxygen (A/F) sensor
Long term fuel trim by front oxygen (A/F) sensor
Intake manifold absolute pressure signal
Engine speed signal
Vehicle speed signal
Ignition timing signal
Amount of intake air
Intake air temperature signal
Throttle position signal
NOTE:
For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
7. LED OPERATION MODE FOR ENGINE
1) On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display screen, select the {Engine} and press the [YES] key.
3) Press the [YES] key after the information of engine type has been displayed.
4) On the «Engine Diagnosis» display screen, select the {Current Data Display & Save}, and then press the
[YES] key.
5) On the «Data Display» screen, select the {Data & LED Display} and press the [YES] key.
6) Using the scroll key, move the display screen up or down until the desired data is shown.
• A list of the support data is shown in the following table.
Remarks
AT/MT identification signal
Test mode signal
Clear memory signal
Neutral position switch signal
Idle switch signal
Ignition switch signal
Power steering switch signal
Steering wheel switch signal
Starter switch signal
Air conditioning switch signal
Subaru Select Monitor
Description
Display
AT Vehicle ID Signal
Test Mode Signal
Clear Memory Terminal
Neutral Position Switch
Idle Switch Signal
Ignition Switch
P/S Switch
Handle Switch
Starter Switch
A/C Switch
EN(H4DOTC)(diag)-27
Display
Freeze frame data
Fuel system for Bank1
Engine Load
Coolant Temp.
Short term fuel trim B1
Long term fuel trim B1
Mani. Absolute Pressure
Engine Speed
Vehicle Speed
Ignition Timing
Mass Air Flow
Intake Air Temp
Throttle Opening Angle
Message
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
RHD or LHD
ON or OFF
ON or OFF
ENGINE (DIAGNOSTICS)
Unit of measure
DTC
ON or OFF
%
°C or °F
%
%
mmHg, kPa, inHg or psig
rpm
km/h or MPH
°
g/s or lb/m
°C or °F
%
LED "ON" requirements
Illuminate (AT model)
When test mode connector is
connected.
Clear memory connector is
connected.
When neutral position signal is
entered.
When idle switch signal is
entered.
When ignition switch is turned
ON.
When power steering switch is
entered.
When handle switch signal is
input.
When starter switch is input.
When air conditioning switch is
input.