Subaru Legacy 2005 Service Manual page 1174

EXHAUST
7) Tighten the bolt which holds center exhaust pipe
to hanger bracket.
Tightening torque:
⋅
35 N m (3.6 kgf-m, 26.0 ft-lb)
8) Lower the vehicle.
9) Install the turbocharger cover.
10) Install the linear motion mounting bracket.
Tightening torque:
⋅
T1: 7.4 N m (0.75 kgf-m, 5.4 ft-lb)
⋅
T2: 40 N m (4.1 kgf-m, 29.5 ft-lb)
T1
(A)
T1
T2
(A) Linear motion mounting bracket
(B) Turbocharger cover
11) Install the linear motion mounting.
<Ref. to ME(H4DOTC)-38, INSTALLATION, Linear
Motion Mounting.>
12) Connect the connector to front oxygen (A/F)
sensor.
13) Lift-up the vehicle.
14) Install the universal joint.
Center Exhaust Pipe
EX-00209
T1
(B)
T1
EX-00250
EX-00205
EX(H4DOTC)-8
(1) Align the bolt hole on the long yoke side of
universal joint with the cutout at the serrated
section of shaft end, and then insert the univer-
sal joint.
(2) Align the bolt hole on the short yoke side of
universal joint with the cutout at the serrated
section of gearbox assembly. Lower the univer-
sal joint completely.
(3) Temporarily tighten the bolt of short yoke
side. Raise the universal joint to make sure the
bolt is properly passing through the cutout at the
serrated section.
(4) Tighten the long yoke side bolt, and also
tighten the short yoke side bolt.
Tightening torque:
⋅
24 N m (2.4 kgf-m, 17.4 ft-lb)
CAUTION:
• Make sure the universal joint bolts are tight-
ened through the shaft serration notches.
• Excessively large tightening torque of uni-
versal joint bolts may lead to heavy steering
wheel operation.
Standard clearance between gearbox and DOJ:
15 mm (0.59 in) or more
15) Install the under cover.
16) Lower the vehicle.
17) Install the intercooler bracket.
18) Install the intercooler. <Ref. to IN(H4DOTC)-
12, INSTALLATION, Intercooler.>
19) Install the collector cover.
EX-00008
EX-00203