Subaru Legacy 2005 Service Manual page 1219

Hide thumbs Also See for Legacy 2005:
Table of Contents

Advertisement

3. Engine Oil
A: INSPECTION
1) Park the vehicle on a level surface.
2) Remove the oil level gauge and wipe it clean.
3) Reinsert the oil level gauge all the way. Be sure
that the oil level gauge is correctly inserted and
properly orientated.
4) Remove the oil level gauge again and check the
engine oil level. If the engine oil level is below the
"L" line, add oil to bring the level up to the "F" line.
5) After turning off the engine, wait a few minutes
for the oil to return to the oil pan before checking
the level.
6) Just after driving or while the engine is warm, en-
gine oil level shows in the range between "F" line
and notch mark. This is caused by thermal expan-
sion of engine oil.
NOTE:
To prevent overfilling of engine oil, do not add oil
above the "F" line when the engine is cold.
(A)
(A) Oil level gauge
(B) Engine oil filler cap
(C) Upper level
(D) Lower level
(E) Approx. 1.02(1.1 US qt, 0.9 Imp qt)
B: REPLACEMENT
1) Open the engine oil filler cap for quick draining of
engine oil.
2) Lift-up the vehicle.
3) Drain the engine oil by loosening the engine oil
drain plug.
Engine Oil
(B)
(C)
(E)
(D)
LU-00213
LU-00219
LU(H4DOTC)-9
4) Tighten the engine oil drain plug after draining
engine oil.
NOTE:
Use a new metal gasket.
Tightening torque:
44 N
m (4.5 kgf-m, 33 ft-lb)
5) Use the engine oil of proper quality and viscosi-
ty, fill the engine oil through oil filler duct to upper
level on level gauge. Make sure that the vehicle is
parked on a level surface when checking oil level.
Recommended oil:
<Ref. to LU(H4DOTC)-2, SPECIFICATION,
General Description.>
Engine oil capacity (when replacing engine oil):
4.0 2 (4.2 US qt, 3.5 Imp qt)
6) Close the engine oil filler cap.
7) Start the engine and warm it up for a time.
8) After the engine stops, recheck the oil level. If
necessary, add engine oil up to the upper level on
level gauge.
(A)
(A) Oil level gauge
(B) Engine oil filler cap
(C) Upper level
(D) Lower level
(E) Approx. 1.02(1.1 US qt, 0.9 Imp qt)
LUBRICATION
LU-00219
(B)
(C)
(E)
(D)
LU-00213

Advertisement

Table of Contents
loading

Table of Contents