Subaru Legacy 2005 Service Manual page 1202

COOLING
8. Radiator Main Fan and Fan
Motor
A: REMOVAL
1) Remove the collector cover.
2) Disconnect the ground cable from battery.
3) Lift-up the vehicle.
4) Remove the under cover.
5) Disconnect the main fan motor connector (A).
6) Remove the heat shield cover from radiator.
(Model without ATF warmer)
7) Drain the coolant about 1 2 (1.06 US qt, 0.88
Imp qt). <Ref. to CO(H4DOTC)-13, DRAINING OF
ENGINE COOLANT, REPLACEMENT, Engine
Coolant.>
Radiator Main Fan and Fan Motor
IN-00203
(A)
CO-00251
CO-00250
CO(H4DOTC)-24
8) Remove the ATF hose from the clip of radiator
main fan motor assembly.
9) Lower the vehicle.
10) Remove the air intake duct.
11) Disconnect the over flow hose.
12) Remove the over flow pipe.
13) Remove the reservoir
CO(H4DOTC)-30, REMOVAL, Reservoir Tank.>
14) Remove the mounting bolts from radiator main
fan motor assembly.
15) Disconnect the radiator inlet hose (A) from ra-
diator.
16) Remove the hood stay holder (B).
17) Remove the radiator main fan motor assembly
from vehicle.
B: INSTALLATION
1) Install the radiator main fan motor assembly to
vehicle.
2) Connect the radiator inlet hose (A) to radiator.
CO-00258
tank. <Ref.
CO-00259
(A)
(B)
CO-00255
to