Subaru Legacy 2005 Service Manual page 1184

COOLING
(A) To automatic transmission
(B) To ATF filter
(1) Radiator lower cushion
(2) Radiator
(3) Radiator upper cushion
(4) Radiator upper bracket
(5) Clamp
(6) Radiator inlet hose
(7) Engine coolant reservoir tank cap
(8) Overflow hose A
(9) Engine coolant reservoir tank
(10) Overflow pipe
(11) Radiator sub fan shroud
(12) Radiator main fan shroud
(13) Radiator sub fan ASSY
(14) Radiator main fan ASSY
(15) ATF hose clamp (AT model)
C: CAUTION
• Wear work clothing, including a cap, protective
goggles and protective shoes during operation.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Be careful not to burn yourself, because each
part on the vehicle is hot after running.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
• Before disconnecting connectors of sensors or
units, be sure to disconnect the ground cable from
battery.
General Description
(16) ATF hose A (Model without ATF
warmer)
(17) ATF hose B (Model without ATF
warmer)
(18) ATF pipe (Model without ATF
warmer)
(19) ATF pipe (Model with ATF warmer)
(20) ATF hose C (Model with ATF
warmer)
(21) ATF hose D (Model with ATF
warmer)
(22) ATF hose E (Model without ATF
warmer)
(23) ATF hose F (Model without ATF
warmer)
(24) Radiator outlet hose
(25) Radiator drain plug
CO(H4DOTC)-6
(26) O-ring
(27) Engine coolant filler tank
(28) Radiator cap (Engine coolant filler
tank cap)
(29) Engine overflow hose
(30) Engine air breather hose
(31) Radiator lower bracket
(32) Overflow hose B
(33) Heat shield cover (Model without
ATF warmer)
⋅
Tightening torque: N m (kgf-m, ft-lb)
T1: 3.4 (0.35, 2.5)
T2: 5.0 (0.5, 3.7)
T3: 7.5 (0.76, 5.5)
T4: 12 (1.2, 8.9)