Subaru Legacy 2005 Service Manual page 1264

ENGINE (DIAGNOSTICS)
9. Subaru Select Monitor
A: OPERATION
1. HOW TO USE SUBARU SELECT MONI-
TOR
1) Prepare the Subaru Select Monitor kit. <Ref. to
EN(H4DOTC)(diag)-7,
General Description.>
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge to Subaru Select Monitor.
<Ref. to EN(H4DOTC)(diag)-7, PREPARATION
TOOL, General Description.>
4) Connect the Subaru Select Monitor to data link
connector.
(1) Data link connector is located in the lower
portion of instrument panel (on the driver's side).
(2) Connect the diagnosis cable to data link
connector.
CAUTION:
Do not connect any scan tools except Subaru
Select Monitor or general scan tool.
Subaru Select Monitor
PREPARATION TOOL,
EN-00038
EN-00039
EN-02097
EN(H4DOTC)(diag)-24
5) Turn the ignition switch to ON (engine OFF), and
the Subaru Select Monitor power switch to ON.
(A) Power switch
6) Using the Subaru Select Monitor, call up DTC
and data, then record them.
2. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE (NORMAL MODE)
Refer to "Read Diagnostic Trouble Code (DTC)" for
information about how to indicate DTCs. <Ref. to
EN(H4DOTC)(diag)-29, Read Diagnostic Trouble
Code (DTC).>
3. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE (OBD MODE)
Refer to "Read Diagnostic Trouble Code (DTC)" for
information about how to indicate DTCs. <Ref. to
EN(H4DOTC)(diag)-29, Read Diagnostic Trouble
Code (DTC).>
(A)
EN-00040