Subaru Legacy 2005 Service Manual page 1178

Hide thumbs Also See for Legacy 2005:

Table of Contents

1) Separate the muffler (RH) from rear exhaust

2) Remove the cushion rubbers, and detach the

Be careful not to drop the muffler during remov-

To facilitate removal, apply a coat of spray type lu-

bricant to the mating area of cushion rubbers in ad-

3) Perform the same procedure for muffler (LH).

B: INSTALLATION

Install in the reverse order of removal.

Use a new gasket and self-locking nut.

Tightening torque:

m (4.9 kgf-m, 35.4 ft-lb)

C: INSPECTION

1) Check the connections and welds for exhaust

2) Check for hole or rust.

3) Check the cushion rubber for wear or crack.

EX(H4DOTC)-12

Chapters

Table of Contents