Omron SYSMAC C500-NC113 Operation Manual page 60

Be sure to put the address at the beginning and set the words as a block.
Note Set the data consecutively, with no gaps. If there are any gaps the data cannot be
properly transferred to the Position Control Unit.
There is no need to be concerned with the order of data addresses when trans-
ferring the data. The Position Control Unit will check the addresses and store
them in the internal RAM accordingly.
Address: 1000
Address: 1005
Note 1. The number of words for the created data that is to be transferred must
match the number of words specified by the Intelligent I/O Write instruction.
If they do not match, the data cannot be properly transferred (e.g., if some
other data is included or if there is not enough data for the number of desig-
nated words, the data may either be treated as an error and not written or
may be written as an error data).
2. Since the NC113 is not provided with the Y axis, do not transfer data to the
data area address for the Y axis (refer to 5-2 Data Handled By the Position
Control Unit ). If data is transferred to this address, a format error (8309) will
occur.
Address
1 block
Number of words configured
under that address
Address
1 block
Number of words configured
under that address
1 block
Address
Number of words configured
under that address
The order of
addresses not
fixed.
Section
Position Control Unit
Address
1000
1005
5-1