Omron SYSMAC C500-NC113 Operation Manual page 215

10-8 Setting Zones
Zone Flag
Settings
10-9 Present Position Resetting Example
Operation
Data Settings
When the present position is within the range set for a zone, the flag for that zone
turns ON.
Present position Present position
Zone setting
Zone 1 CW side: --100
Zone 1 CCW side: --400
In this example, feeding is executed (using INDEPENDENT START) with a giv-
en point as the basis. The same positioning action and the present position reset
are used alternately.
Origin
search
Proximity
Origin or encoder's
Z-phase signal
Positioning Action (Addresses 1000, 5000)
Speed number:
Acceleration/deceleration pattern:
Dwell time:
Output code:
Completion code:
Target position:
Parameters
Origin return speed number (addresses 2000, 6000):
Initial speed number (addresses 2001, 6001):
Initial position number (addresses 2002, 6002):
Origin search high speed number (addresses 2005, 6005):
Origin search proximity speed number (addresses 2006, 6006): 2
Present position change set value (addresses 2022, 6022):
Origin search mode, origin search pattern, origin type
Origin search mode:
Origin search pattern:
Origin search direction:
Origin proximity signal enable:
Origin proximity signal type:
Origin signal type:
Origin search method:
Origin
Origin forced by present position reset
0
0
0
0
3
CW 10,000 pulses (absolute)
(addresses 2021, 6021)
0
0
CW
Enabled
N.O. contact
N.O. contact
No proximity reversal
Section 10-9
Time
0
0
0
1
0