Figure 2-37 Normalized Trace - Agilent Technologies 8560E User Manual

The units of the reference level, dB, reflect this relative measurement
(see Figure 2-37).
• To normalize, press
An arrow appears on each side of the graticule when normalization is
activated. These two arrows mark the normalized reference position, or
the position where 0 dB insertion loss (transmission measurements) or
0 dB return loss (reflection measurements) will normally reside.
You can set the dB value of the normalized reference position using the
NORM REF LVL
NORM REF POSN
the range of the graticule.
Figure 2-37 Normalized Trace
Measure
Measure the range using the delta markers:
1. Press
2. Use the knob to position the second marker in the rejection area of
Chapter 2
NORMLIZE ON OFF
softkey is located on the first page of the tracking-generator menu.)
adjustment under the
changes the position of the normalized trace, within
,
PEAK SEARCH
the bandpass filter as shown in Figure 2-38.
Example 7: Stimulus-Response Measurements
until ON is selected. (This
AMPLITUDE
.
MARKER DELTA
Making Measurements
key. Changing
91