Agilent Technologies 8560E User Manual page 360

Programming Command Cross Reference
Programming Command Versus Front Panel Key
Table 6-2 Programming Command Functional Index
Function
Category
SERVICE
REQUEST
SPAN
SWEEP
SYNCHRONI-
ZATION
360
Command Corresponding Key
Function
PSTATE SAVELOCK ON OFF
RCLS RECALL STATE
RCLT RECALL TO TRA
RECALL TO TRB
SAVES
PWR ON STATE
SAVE STATE
SAVET SAVE TO TRA
SAVE TO TRB
RQS
SRQ
STB
FS FULL SPAN
SP SPAN ZERO SPAN
CONTS
SWEEP CONT SGL
(CONT)
DLYSWP
DLY SWP [ ] DLY SWP ON
OFF
GATE GATE ON OFF
GATECTL GATE CTL EDGE LVL
GD GATE DLY [ ]
GL GATE LEN [ ]
GP EDGE POL POS NEG LVL
POL POS NEG
MEAS
SNGLS SWEEP CONT SGL (SGL) Selects single sweep mode (S2).
ST
SWP TIME AUTO MAN
TS
DONE
TS
Description
Protects saved states (save lock).
Recalls previously saved state
(RC).
Recalls specified trace data.
Saves current state of the analyzer
in the specified register (SV).
Saves specified trace data.
Specifies the decimal weighing of
status byte bits that are allowed
during service request. RQS is set
to 0 with power-up or device clear.
Sets service request if operand bits
are allowed by RQS.
Returns the decimal equivalent of
the bits set in the status byte.
Specifies the full frequency span
for the spectrum analyzer.
Specifies the frequency span.
Selects continuous sweep mode
(S1).
Delays the start of the sweep until
the specified time elapses after the
trigger event (or before the trigger
event with Option 007).
Turns on or off the time-gating
function.
Selects between the edge and the
level mode for time-gate function.
Sets the delay time from when the
gate trigger occurs to when the
gate is turned on.
Sets the length of time the time
gate is turned on.
Sets the polarity (positive or
negative) for the gate trigger.
Queries whether the instrument is
sweeping continuously, or a single
time.
Specifies sweep time.
Takes a sweep.
Returns a 1 when task has been
completed.
Takes a sweep.
Chapter 6