Adjif Adjust If; Figure 7-43 Adjif Syntax - Agilent Technologies 8560E User Manual

Language Reference

ADJIF Adjust IF

ADJIF Adjust IF
Syntax
Figure 7-43 ADJIF Syntax
Description
The ADJIF command turns the automatic IF adjustment on or off. This
function is normally on. Because the IF is continuously adjusting,
executing the IF alignment routine is seldom necessary. When the IF
adjustment is not active, an "A" appears on the left side of the display.
Parameters
OFF
ON
FULL
CURR
Preset State
On
410
turns the continuous IF adjustment off.
reactivates the continuous IF adjustment.
IF adjustment is done for all IF settings.
IF adjustment is done only for the IF settings currently
displayed.
Chapter 7