Making Measurements
Example 9: Adjacent Channel Power Measurement
Figure 2-53
Adjacent Channel Power Parameters
The first step is to set the spectrum analyzer to display the signal under
test.
1. Press
2. Input the frequency of the transmitted carrier by pressing
3. Press
110
on the spectrum analyzer to start the measurement
PRESET
from a defined preset state.
,
FREQUENCY
CENTER FREQ
the carrier signal (in this case, 300 MHz for the calibrator signal).
, then the step down
AMPLITUDE
reference level to −10 dBm.
, and entering the center frequency of
⇓
key once to set the signal
Chapter 2