Plot Plot Display; Figure 7-204 Plot Syntax - Agilent Technologies 8560E User Manual

Language Reference

PLOT Plot Display

PLOT Plot Display
Syntax
Figure 7-204 PLOT Syntax
Description
The PLOT command copies the specified display contents onto any
HP-GL plotter. Set the plotter address to 5, select the P1 and P2
positions, and then execute the plot command. P1 and P2 correspond to
the lower-left and upper-right plotter positions, respectively. If P1 and
P2 are not specified, default values (either preloaded from power-up or
sent in via a previous plot command) are used. Once PLOT is executed,
no subsequent commands are executed until PLOT is done. For more
information, refer to Chapter 5.
Parameters
P1X, P1Y
P2X, P2Y
554
plotter-dependent values that specify the lower-left
plotter position.
plotter-dependent values that specify the upper-right
plotter position.
Chapter 7