Table of Contents
Advertisement
IDCF Signal Identification to Center
Frequency
Syntax
Figure 7-140
IDCF Syntax
Description
The IDCF command sets the center frequency to the frequency obtained
from the command SIGID. SIGID must be in AUTO mode and have
found a valid result for this command to execute properly. Use SIGID
on signals when in external mixing mode. IDCF only applies to
spectrum analyzers with firmware revisions ≤920528 or with Option
008. The command does not apply to an 8560E/EC Option 002 or when
the spectrum analyzer is configured to use preselected external mixers.
Example
10
20
30
40
50
60
Chapter 7
OUTPUT 718;"SIGID AUTO;"
OUTPUT 718;"IDCF;"
OUTPUT 718;"CF?;"
ENTER 718;Cf
PRINT Cf
END
IDCF Signal Identification to Center Frequency
Language Reference
493
Advertisement
Table of Contents
