Table of Contents
Advertisement
The next example processes trace information with a marker command,
MKPK HI (marker peak highest), which selects the highest amplitude
level in the trace. Because the program changes the measurement
range, the trace information must be updated with TS before MKPK HI
is executed. E
XAMPLE
the marker commands.
Connect the calibrator signal to the analyzer INPUT 50Ω before
performing this example.
10
CLEAR 718
20
OUTPUT 718;"IP;SNGLS;"
Initialize analyzer.
30
OUTPUT 718;"SP 1MHZ;CF 300MHZ;RL -5DBM;"
Change
measurement
range.
40
OUTPUT 718;"TS;"
Update trace.
50
OUTPUT 718;"MKPK HI;"
Place marker on highest signal
level.
60
END
Chapter 5
. Use TS to update trace information before using
Programming
Program Timing
301
Advertisement
Table of Contents
