Agilent Technologies 8560E User Manual page 355

Table 6-2 Programming Command Functional Index
Function
Category
CALIBRA TION
CONFIGURATION
COPY
Chapter 6
Command Corresponding Key
Function
ADJALL REALIGN LO &IF
ADJCRT CRT ADJ PATTERN
ADJIF IF ADJ ON OFF ADJ
CURR IF STATE
FULL IF ADJ
AMPCOR AMPCOR ON OFF
AMPCORDATA EDIT AMPCOR
AMPCOR SIZE
AMPCOR RCL
RECALL AMPCOR
AMPCOR SAVE
SAVE AMPCOR
FDIAG FREQ DIAG LO FREQ
SAMPLER FREQ
SAMPLER HARMONIC,
FRAC N FREQ,
POSTSCLR, RAW OSC
FREQ
RLCAL REF LVL ADJ
EXT MXR EXT MXR PRE UNPR
ID DATECODE OPTIONS
OP
PLOT COPY
PLOTORG PLOT ORG DSP GRT
PLOTSRC
PLOT ANNOT
PLOT GRATICUL
PLOT ORG DSP GRAT
PLOT TRACE A
PLOT TRACE B
PRINT
COPY
REV
DATECODE &OPTIONS
SER DATECODE &OPTIONS
PLOT COPY with COPY DEV
PRNT PLT
PRINT COPY with COPY DEV
PRNT PLT
Programming Command Cross Reference
Programming Command Versus Front Panel Key
Description
Initiates power-on adjustment
sequence.
Initiates CRT adjustment
patterns.
Initiates IF adjustment sequence.
Turns on and off the correction for
system flatness.
Enters amplitude correction data.
Indicates the number of correction
points.
Recalls ampcor data.
Saves ampcor data.
Returns frequency of specified
oscillator.
Calibrates reference level.
Selects either preselected or
unpreselected external mixing
mode.
Returns the model number of
analyzer used.
Returns the display lower-left and
upper-right coordinates.
Sends analyzer display to a
plotter.
Selects scaling points for plot.
Specifies plot source.
Sends analyzer display to a
printer.
Returns analyzer firmware
revision date.
Returns analyzer serial number.
Sends analyzer display to a
plotter.
Sends analyzer display to a
printer.
355