Table of Contents
Advertisement
Activates a 3 line display of the current
SCROLL CORR PTS
frequency-amplitude correction data. Each correction
point consists of a frequency at which the correction
should be applied and an amplitude, in dB, of the
correction. The list of correction points is sorted in
order by frequency and is numbered.
The currently selected frequency-amplitude correction
pair is marked with an *. You can scroll through the list
of correction pairs by using the knob, or by using the
step-keys. You can go directly to the point that you wish
to edit by entering its number using the numeric
keypad and pressing one of the terminator keys.
Front-panel key access:
Causes the currently selected character in the active
SELECT CHAR
function block to appear in the next available character
position of the title, which is indicated by a blinking
dot. This key may be held down for repeated characters.
Front-panel key access:
Selects the single sweep mode and triggers a sweep if
SGL SWP
the spectrum analyzer is in continuous sweep mode. If
the analyzer is in the single sweep mode, pressing
SWP
Front-panel key access:
For firmware revisions ≤920528 or for Option 008 only.
SIG ID→ CF
Sets the center frequency to the frequency obtained
from the softkey SIG ID AT MKR. If the frequency is
outside the range of the analyzer, no action takes place.
If no signal identification has previously been
performed, the message DO: SIG ID AT MKR
momentarily appears in the active function block, and
no other action takes place. Use this function only after
executing SIG ID AT MKR.
Front-panel key access:
Chapter 4
CAL
DISPLAY
triggers another sweep.
SGL SWP
AUX CTRL
Key Function Descriptions
Key Descriptions
SGL
277
Advertisement
Table of Contents
