Agilent Technologies 8560E User Manual page 217

Amplitude units are not available in normalized mode.
NOTE
ANALOG METHOD
ANALYZER ADDRESS
ANNOT HELP
A
C
D
E
F
G
K
M
N
R
S
T
Chapter 4
Makes adjacent channel power (ACP) measurements
by measuring continuous power integration versus
frequency. Uses an analog method that measures the
power in the main and adjacent channels assuming a
continuous carrier. The rms power of that carrier is
detected using power detection. This is done by using a
video bandwidth that is much wider than the resolution
bandwidth. Then the power, not the log of the power, of
each measurement cell is added. This method is used
for measuring analog FM systems.
Front-panel key access:
Displays the current GPIB address of the
spectrum analyzer. A new address can be entered by
using the data keys (and pressing
keys, or the knob. You should press STORE HPIB ADR
once the GPIB address has been entered. If you do not
press STORE HPIB ADR, the redefined GPIB address
is retained if
the spectrum analyzer is turned off.
Front-panel key access:
Defines the annunciators that appear in the special
functions area at the left side of the display screen. The
annunciators are:
IF adjust turned OFF
DC coupling selected (ac coupling is default)
Detector mode set to sample, negative peak, or positive peak
Special sweep-time equations in use (Refer to tracking
generator SWP CPL SR SA key for more information.)
Frequency offset is less than or greater than 0 Hz
Internal tracking generator is on
Signal track is on
Trace math is on
Normalization is on
Reference level offset is less than or greater than 0 dB
Single-sweep mode
Trigger mode set to line, video, or external
MEAS/USER
is pressed, but not if the power to
PRESET
CONFIG
Key Function Descriptions
Key Descriptions
), the step
ENTER
217