Programming
Program Timing
The previous program example does not measure with the new
analyzer settings as depicted by the data-invalid indicator "*" in the
upper right corner. To obtain valid trace information, the trace must be
updated with the TS command. Here is the program again, corrected to
include the TS command. E
then update trace information.
Connect the calibrator signal to the analyzer 50Ω INPUT before
performing this example.
10
20
Initialize analyzer.
30
Change measurement
range.
40
Measure with trace A.
50
Figure 5-6
Updated Trace Information
300
CLEAR 718
OUTPUT 718;"IP;SNGLS;"
OUTPUT 718;"SP 1MHZ;CF 300MHZ;"
OUTPUT 718;"TS;"
END
. Change the measurement range,
XAMPLE
Chapter 5