Setup Procedure For Remote Operation - Agilent Technologies 8560E User Manual

Setup Procedure for Remote Operation

The following procedure describes how to connect your equipment for
remote operation of the 8560 E-Series or EC-Series spectrum analyzers.
Refer to the Chapter 1 for more information on installing, configuring,
NOTE
and addressing the system.
1. Connect computer, spectrum analyzer system, and other peripherals
2. After the GPIB cables are installed, reset all instruments connected
3. Check the GPIB address of the spectrum analyzer by pressing
Chapter 5
with GPIB cables. The Agilent 85620A mass memory module can be
attached for downloadable programming (DLP) capabilities. Turn off
the analyzer before installing or removing any option module.
to the bus. (If you are not sure how to reset a device, switch off the
line power to the device, and then switch the line power back on to
reset it.)
, then ANALYZER ADDRESS. Note that examples in this
CONFIG
section, use GPIB address 18.
Programming
Setup Procedure for Remote Operation
291