Table of Contents
Advertisement
Quick Start Guide
Front Panel Overview
14.Active special functions: the following characters appear in a
Table 1-3
A =
C =
D =
E =
F =
G =
K =
M =
N =
R =
S =
T =
W =
X =
+ =
− =
15.Active function area
16.Message area (for example, messages such as MEAS UNCAL, PEAKING,
17.Marker indicator
18.Indicator of reference-level position when in normalized mode
19.Reference level
20.Input attenuator value (internal mixing) or conversion loss (external
40
vertical line alongside the graticule. This information is also
available by pressing
IF adjust turned OFF
DC coupling selected (The 8563E/EC, 8564E/EC, and 8565E/EC
are always dc coupled. AC coupling is available only for an
8560E/EC, 8561E/EC or 8562E/EC spectrum analyzers. The
default setting for an 8560E/EC, 8561E/EC or 8562E/EC is ac
coupling.)
Detector mode set to sample, negative peak, or positive peak
Special sweep-time equations in use (refer to tracking generator
menus)
Frequency offset is less than or greater than 0 Hz
Internal tracking generator is ON
Signal track is ON
Trace math is ON
Normalization is ON
Reference level offset is less than or greater than 0 dB
Single-sweep mode
Trigger mode set to line, video, or external
Amplitude correction (ampcor) is on
10 MHz reference is external
External mixer bias is greater than 0 mA
External mixer bias is less than 0 mA
and Sampling are displayed in the message area)
mixing)
, then
DISPLAY
ANNOT HELP
.
Chapter 1
Advertisement
Table of Contents
