Rlcal Reference Level Calibration; Figure 7-229 Rlcal Syntax - Agilent Technologies 8560E User Manual

Agilent technologies 8560 e-series and ec-series spectrum analyzers

Table of Contents

RLCAL Reference Level Calibration

Figure 7-229

RLCAL Syntax

The RLCAL command allows you to calibrate the reference level

remotely or check the current calibration. To calibrate the reference

level, connect the 300 MHz calibration signal to the RF input. Set the

center frequency to 300 MHz, the frequency span to 20 MHz, and the

reference level to −10 dBm. Use the RLCAL command to move the input

signal to the reference level. When the signal peak falls directly on the

reference-level line, the reference level is calibrated. Storing this value

in the analyzer in EEROM can be done only from the front panel. The

RLCAL command, when queried, returns the current value.

integer from −528 to 528.

(−33 to +33 for ﬁrmware revisions ≤920528)

Language Reference

RLCAL Reference Level Calibration