Table of Contents
Advertisement
Key Function Descriptions
Key Descriptions
NOTE
SAVE TRACE A
registers in which to store trace data. Be careful not to overwrite
previously saved trace data.
Trace-registers 5, 6, and 7 should not be used when using an Agilent
85620A mass memory module. These registers are used by the module
and may be overwritten if data has been previously stored in them.
SAVE TRACE B
SAVE LOCK ON OFF
SCREEN TITLE
276
and
use exactly the same eight save-trace
SAVE TRACE B
Front-panel key access:
Displays a menu of eight registers in which the current
contents of trace B can be stored. The save-trace
registers appear on two menus: TRACE 0 through
TRACE 4 on the first page, and TRACE 5 through
TRACE 7 on the second page. To store current trace B
data in a desired register, press the softkey next to the
register number, or enter the number using the data
keys. Terminate the entry with any units key (
and so on).
Front-panel key access:
Prevents storing any new data in the state or trace
registers. When SAVELOCK ON OFF is ON, the
registers are "locked"; the data in them cannot be
erased or overwritten, although the data can be
recalled. To "unlock" the registers and store new data,
switch SAVELOCK ON OFF to OFF.
Front-panel key access:
Displays a menu of functions that allow you to create a
title on the screen or to erase an existing title. SCREEN
TITLE also displays a set of characters in the active
function block. Use the step keys or the knob to select
the desired characters for your title. After selecting the
desired character, press SELECT CHAR to place it in
the title area, which is in the upper-right corner of the
graticule. The title can be up to two lines of 16
characters each.
Front-panel key access:
SAVE
SAVE
SAVE
DISPLAY
,
,
Hz
kHz
Chapter 4
Advertisement
Table of Contents
