Accessories Available - Agilent Technologies 8560E User Manual

Accessories Available

A number of accessories are available from Agilent Technologies to help
you configure the spectrum analyzer for your specific needs.
Agilent 85629B test and adjustment module Not available for the
Agilent 8564E/EC or Agilent 8565E/EC. The Agilent
85629B adds four test and repair procedures to the
8560E/EC, Agilent 8561E/EC, Agilent 8562E/EC, and
Agilent 8563E/EC spectrum analyzers:
• Functional Tests.
• Adjustment Procedures.
• Diagnostic (troubleshooting) Procedures.
• Automatic Alignment Routines.
When connected to the rear panel of the spectrum
analyzer, the module displays menus, procedures, and
results on the display of the spectrum analyzer . While
testing with the module, the spectrum analyzer
controls other instruments over GPIB, reads data, and
formats that data for the user. In addition to a large
program stored in ROM, the module has the necessary
hardware for troubleshooting, including dc signal
injection and detection. The Agilent 8562E/TAM
Interface Software is required when using the TAM
with the Agilent 8562E or Agilent 8562EC spectrum
analyzer.
Agilent 85640A portable tracking generator adds scalar analysis
capability from 300 kHz to 2.9 GHz. Measure gain,
frequency response, compression, flatness, and return
loss on components and subsystems. A built-in
attenuator provides an output power range of −80 to 0
dBm.
Agilent 8721A directional bridge has a frequency range of 100 kHz
to 100 MHz. This bridge is used in return-loss
measurements. It has 6 dB insertion loss and is 6 dB
coupled to the auxiliary arm. Frequency response is
+0.5 dB (0.1 to 110 MHz); directivity is greater than 40
dB (1 to 110 MHz); load-port return loss is less than
0.03; maximum input power is +20 dBm.
Chapter 8
Options and Accessories
Accessories Available
659