Agilent Technologies 8560E User Manual page 194

Key Function Descriptions
Key Function Tables
Table 4-2 Instrument State Functions
Instrument State
Keys
PWR ON STATE
PWR SWP ON OFF
RANGE LVL
RAW OSC FREQ
REALIGN LO IF
REAR PANEL
RECALL
RECALL AMPCOR
RECALL ERRORS
RECALL OPN/SHRT
RECALL PRSEL PK
RECALL STATE
RECALL THRU
RECALL TO TR A
RECALL TO TR B
194
Description
Access Key
SAVE Saves the current state in the power-on register. The
spectrum analyzer is set to this state whenever LINE is
turned on or when POWER ON is pressed.
Switches the power-sweep function on and off. The
AUX CTRL
tracking generator output power sweeps over the
chosen amplitude range.
Activates the dynamic range level function and
AUX CTRL
ensures there is no signal compression in the displayed
range. For use with NORMLIZE ON OFF.
Displays the value of the oscillator frequency, which is
CAL
used to generate the fractional N frequency.
Activates the LO and IF alignment routines for a
CAL
complete LO and IF alignment.
AUX CTRL Accesses a menu for selecting the signals available at
connectors J8 (LO SWP|FAV OUTPUT) and J9 (10
MHz REF IN/OUT).
— Accesses a menu of functions that recall instrument
data.
CAL Recalls a previously stored table of amplitude
correction (ampcor) points.
RECALL Displays the last error that has occurred. Use the step
keys to cycle through accumulated errors.
Recalls the stored, averaged open/short calibration
AUX CTRL
data into trace B and sets the instrument to the
calibration state.
RECALL Recalls the preselector data initially stored in the user
table using SAVE PRSEL PK.
Displays a menu of ten registers from which
RECALL
instrument states can be recalled and displayed.
Recalls stored thru calibration data into trace B and
AUX CTRL
sets the instrument to the calibration state.
RECALL Displays a menu of eight registers from which data can
be recalled and placed in trace A.
RECALL Displays a menu of eight registers from which data can
be recalled and placed in trace B.
Chapter 4