Step 5: Connect Power To The Acx Series Router; Connect Power To An Ac-Powered Acx500 Outdoor Router - Juniper ACX500 Quick Start Manual

Universal access routers. outdoor routers

Hide thumbs Also See for ACX500:

Table of Contents

Step 5: Connect Power to the ACX Series Router

Depending on your configuration, your router uses either AC or DC power supplies. Perform

the appropriate procedures for each power supply in your router.

Power cords for the ACX500 outdoor routers does not come with the router. They must

be purchased separately. These power cords are specifically designed to be used only

with the specified ACX500 outdoor routers.

NOTE:

Before making the AC or the DC power connection to the router, ensure

that you disconnect power at the circuit breaker of the PDU, or the AC or

the DC power connection box. Only when the connection is properly

completed, switch on the breaker.

To meet IEC/EN 60950-22 requirements, ensure additional protection is

provided external to this equipment to reduce transient surge from OVC

IV to OVC II at the input of this unit. The over voltage and fault current

protection component used to achieve this protection must comply with

IEC 61643.

To meet CSA/CAN 22.2, UL 60950-22 requirements, use an alternative

component to provide additional protection. These component must

comply to ANSI/IEEE C62.11, CSA certification notice no.516, CSA 22.2 No.1,

or UL 1449.

Connect Power to an AC-Powered ACX500 Outdoor Router on page 15

Connect Power to a DC-Powered ACX500 Outdoor Router on page 16

To connect power to the AC-powered router, you need the following tools:

AC power cords for the ACX500 outdoor router (not provided, must be purchased

separately)

ESD grounding wrist strap

NOTE:

Use the power cord that is purchased from Juniper Networks, and

which is compatible with the ACX500 outdoor router. Using a power cord

other than that is provided by Juniper Networks with the router can damage

the power terminal.

WARNING:

You must ground the router before connecting the power cables.

Step 5: Connect Power to the ACX Series Router

Table of Contents