Checking The Start-In-Gear Protection (Manual Starter Model); Checking The Engine Idle Speed - SELVA MARINE Wahoo 15 Service Manual

CHK
ADJ
6. Adjust the shift rod adjusting nut 4.
4
NOTE:
To adjust the shift rod adjusting nut, see
"Installing the lower unit" (6-17).
7. Check the gear shift for smooth opera-
tion.
Checking the start-in-gear protection
(manual starter model)
CAUTION:
Be sure to remove the clip from the
engine stop lanyard switch before check-
ing the start-in-gear protection.
1. Set the shift lever to the forward or
reverse position, and then check that the
starter handle cannot be pulled. If the
starter rope can be pulled out normally,
adjust the start-in-gear protection cable.
2. Set the shift lever to the neutral position
and loosen the locknut 1. Align the
cable end a with the mark b on the
manual starter cover by turning the
adjusting nut 2.
3. Tighten the locknut 1.
3-11
Periodic check and adjustment
S6AG3470
2
1

Checking the engine idle speed

1. Start the engine and warm it up for 10
3
minutes.
NOTE:
Because the Prime Start operates when the
engine is started, the engine idle speed will
be above specification. Therefore, check and
adjust the engine idle speed after the engine
has been warmed up.
2. Attach the special service tool to spark
plug wire #1 1, and then check the
engine idle speed. Adjust if out of specifi-
cation.
Digital tachometer: 90890-06760
a
b
S6AG3140
1
S6AG3150
6AG3J11
3