Installing The Starter Motor; Charging System; Checking The Stator Coil - SELVA MARINE Grey Whale 200 EFI Service Manual

K
M
M M
M
M
L
K
NOTE:
• Install each planetary gear M with its
rounded side facing upward.
• Check the operation of the starter motor
before installing it to the power unit. To
check the operation of the starter motor,
see Chapter 8, "Checking the starter motor
operation."

Installing the starter motor

1. Install the starter motor to the power unit.
2. Install the wiring harness 1 to the starter
motor, and then fasten the wiring har-
1
ness and
(brown/white) 3 with the holders 2.
3
6AL3J11
F M L
N
S6AL8330
starter motor lead
2
1
S6AL8850
Starter motor / Charging system
3. Route the starter
(brown/white) 3 as shown, fasten it to
the junction box using the plastic ties 4,
and then install the terminals of the
starter motor lead (brown/white) 7 and
wiring harness lead (brown) 5 using the
same bolt 6.
7 5
6
STBD
NOTE:
To wire the starter motor lead (brown/white),
see Chapter 8, "Wiring harness routing."
4. Install the starboard intake manifold and
intake silencer.
NOTE:
To install the intake manifold, see Chapter 4,
"Installing the intake manifold."

Charging system

Checking the stator coil

1. Remove the starboard intake manifold.
2. Disconnect the stator coil couplers, and
then install the starboard intake manifold.
NOTE:
• When installing the starboard intake mani-
fold at this time, be sure to leave the stator
coil couplers on the outside of the manifold.
• To install the starboard intake manifold, see
Chapter 4, "Installing the intake manifold."
motor lead
1
2
5
3
4
3
4
S6AL8870
5
6
7
8
8
9
8-50