Installing The Starter Motor; Starting System; Checking The Fuse (Electric Starter Model); Checking The Engine Start Button (Tiller Handle Model With Electric Starter) - SELVA MARINE Wahoo 15 Service Manual

J
I
H
G
NOTE:
• Install the pinion stopper I in the direction
shown.
• Check the starter motor operation again
after assembling it.

Installing the starter motor

1. Install the starter motor to the power unit.
2. Install the wiring harness to the starter
motor, and then fasten the wiring har-
ness.
NOTE:
To wire the starter motor, see "Electrical
component and wiring harness routing" (8-1).

Starting system

Checking the fuse (electric starter
model)
1. Check the fuse for continuity. Replace if
there is no continuity.
NOTE:
For the location of the fuse, see "Electrical
component and wiring harness routing" (8-1).
6AG3J11
Starter motor (electric starter model) / Starting system
Checking the engine start button
J
(tiller handle model with electric
starter)
I
1. Disconnect the engine start button 1
H
connectors.
2. Measure the input voltage between the
G
connector (wiring harness end) of the
engine start button 1 and the ground.
S6AG8510
Check the fuse 2 and wiring harness if
below specification.
8
8
8
1
R R
Br
R
Br
Br
Engine start button input voltage
(reference data):
Red (R) – Ground
12 V (battery voltage)
8
1
2
3
4
2
5
R
R
6
S6AG8170
7
8
9
8-18