Checking The Filter; Assembling The Gear Pump - SELVA MARINE Wahoo 15 Service Manual

BRKT

Checking the filter

1. Check the gear pump filters. Clean if
there is dirt or residue.
NOTE:
See the exploded diagram for the filter instal-
lation position (7-35).

Assembling the gear pump

CAUTION:
• Do not use a rag when assembling the
power tilt unit as dust and particles on
the power tilt unit components can lead
to poor performance.
• Do not reuse the O-ring, always replace
it with a new one.
NOTE:
Lubricate the parts with ATF Dexron II during
assembly.
1. Install the drive gear 1, driven gear 2,
balls 3, dowels 4, and main valves 5
to the tilt cylinder 6.
2
5
6
2. Install shuttle piston 1 7 and shuttle pis-
ton 2 8 to the gear pump housing 9,
and then install the gear pump housing
9 to the tilt cylinder.
3. Install the filters 0, plate A and gear
housing bolts B, and then tighten the
bolts to the specified torque.
7-39
Bracket unit
1 5
4
3
4
S6AG7190
7
7
7
8
NOTE:
Be sure to install shuttle piston 1 7 and shut-
tle piston 2 8 in the correct positions; the pis-
ton shapes are different.
Gear housing bolt B:
5 N·m (0.5 kgf·m, 3.7 ft·lb)
4. Install the balls C, relief valve seals D,
manual release pins E, and spring F to
the tilt cylinder.
5. Install the manual valve G and O-ring H
to the power tilt motor base.
7
9
0
A
8
0
B
S6AG7200
0
S6AG7201
6AG3J11