Assembling The Drive Shaft Housing; Installing The Shift Rod, Drive Shaft Housing, And Drive Shaft - SELVA MARINE Wahoo 15 Service Manual

LOWR

Assembling the drive shaft housing

1. Install the bushing into the drive shaft
housing using a press.
2
NOTE:
Align a groove a in the bushing with the hole
b in the drive shaft housing.
Driver rod L3 1: 90890-06652
Bushing attachment 2:
90890-06649
2. Apply grease to new oil seals, and then
install them into the drive shaft housing
to the specified depth.
A A
NOTE:
Install an oil seal halfway into the drive shaft
housing, and then install the other oil seal.
6-15
Lower unit
a
1
b
G
S6AG6310
3
c
4
S6AG6320
6
Driver rod L3 3: 90890-06652
Needle bearing attachment 4:
90890-06613
Installation depth c:
7.0–8.0 mm (0.28–0.31 in)
Installing the shift rod, drive shaft
housing, and drive shaft
1. Install the forward gear assembly 1 into
the lower case.
2. Install the drive shaft sleeve 2 into the
lower case.
NOTE:
Install the drive shaft sleeve 2 with the hole
a facing forward.
3. Install the shift rod, a new gasket 3, and
the drive shaft housing assembly 4.
NOTE:
Make sure that the projection b on the gas-
ket is toward the port side.
4. Install the drive shaft 5, thrust bearing
6, original pinion shim(s) 7, pinion 8,
and pinion nut 9 into the lower case.
4
3
a
5
b
2
6
7
8
9
1
G
S6AG6330J
6AG3J11
6
G