Installing The Water Pump And Shift Rod - SELVA MARINE Blue Whale 250 EFI Service Manual

NOTE:
• Be sure to select the propeller shaft shim if
replacing propeller shaft, forward gear or
reverse gear.
• To select the shims, see "Shimming (regu-
lar rotation model)."
4. Install the propeller shaft housing assem-
bly into the lower case, and then tighten
the bolts 4 to the specified torque.
5. Install the ring 5 and bolts 6.
Propeller shaft housing bolt 4:
30 N·m (3.0 kgf·m, 22.1 ft·lb)
6. Install the water pipe and rubber seals.
Installing the water pump and shift
rod
1. Install the shift rod assembly 1.
6P23H11
Drive shaft and lower case (regular rotation model)
NOTE:
• Check the gear shift to the neutral position,
when installing the shift rod.
• After assembling the lower unit, check that
the shift rod operates smoothly, and check
that the drive shaft and propeller shaft
rotate smoothly.
2. Install a new gasket 2, the outer plate
cartridge 3, and dowels 4.
1
2
3
4
5
6
7
8
9
6-18