Installing The Water Pump And Shift Rod - SELVA MARINE Grey Whale 200 EFI Service Manual

NOTE:
• Be sure to select the propeller shaft shim if
replacing the propeller shaft, forward gear,
or reverse gear.
• To select the shims, see Chapter 6, "Shim-
ming (regular rotation model)."
4. Install the propeller shaft housing assem-
bly into the lower case, and then tighten
the bolts 4 to the specified torque.
5. Install the ring 5 and bolts 6.
Propeller shaft housing bolt 4:
30 N·m (3.0 kgf·m, 22.1 ft·lb)
6. Install the water pipe and rubber seals.
Installing the water pump and shift
rod
1. Install the shift rod assembly 1.
6AL3J11
Drive shaft and lower case (regular rotation model)
NOTE:
• Set the gear shift to the neutral position
when installing the shift rod.
• After assembling the lower unit, check that
the shift rod operates smoothly, and check
that the drive shaft and propeller shaft
rotate smoothly.
• When measuring the backlash, be sure to
measure it before installing the water
pump. To measure the backlash, see
Chapter 6, "Measuring the forward and
reverse gear backlash (regular rotation
model)."
1
2
3
4
5
6
7
8
9
6-18