Installing The Water Pump; Installing The Lower Unit - SELVA MARINE Dorado 50 EFI Service Manual

LOWR

Installing the water pump

1. Install a new gasket 1, the outer plate
cartridge 2, and dowels 3.
2. Install the Woodruff key into the drive
shaft.
3. Align the groove in the impeller 4 with
the Woodruff key 5, and then install the
impeller onto the drive shaft.
4. Install the insert cartridge 6 into the
pump housing 7, and then apply grease
to the inside of the insert cartridge.
6-19
Lower unit
NOTE:
Align the insert cartridge projection a with
the hole b in the pump housing.
5. Install the new O-ring 8 and pump hous-
ing assembly 9 into the lower case,
tighten the bolts 0, and then install the
seal A and cover B.
NOTE:
• When installing the pump housing, apply
grease to the inside of the housing, and
then turn the drive shaft clockwise while
pushing down the pump housing.
• Align the cover projection c with the hole
d in the pump housing.

Installing the lower unit

1. Set the gear shift to the neutral position
at the lower unit.
6C13G11